In the block help, you can check the configuration parameters: Select the door in the library as shown in the image below:ĭrag to the line and configure the block according to the modbus network configuration, 9600/7/E/1 ASCII ID1: You can use the block to set the serial port configuration:.The MOV value in the first line of 16#0086 for word D1120, is using the bit sequence shown in the image below, to configure the COM2 port in RS485 modbus as: 7, E, 1, 9600: Moving values to specific serial port configuration memories, such as COM2 in modbus 485 network, with baud rate (9600), data bits (7), parity (even), stop bit (1), ASCII and PLC ID parameters like 1.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |